Remove Reboot-Required Software Updates¶

Updates in the Applied or Partial-Apply states can be removed if necessary, for example, when they trigger undesired or unplanned effects on the cluster.

About this task

Rolling back updates is conceptually identical to installing updates. A roll-back operation can be commanded for an update in either the Applied or the Partial-Apply states. As the update is removed, it goes through the following state transitions:

Applied or Partial-Apply to Partial-Remove

An update in the Partial-Remove state indicates that it has been removed from zero or more, but not from all, the applicable hosts.

Use the command sw-patch remove to trigger this transition.

Partial-Remove to Available

Use the command sudo sw-patch host-install-async <hostname> repeatedly targeting each one of the applicable hosts in the cluster. The transition to the Available state is complete when the update is removed from all target hosts. The update remains in the update storage area as if it had just been uploaded.

Note

The command sudo sw-patch host-install-async <hostname> both installs and removes updates as necessary.

The following example describes removing an update that applies only to the controllers. Update removal can be done using the Horizon Web interface as discussed in Install Reboot-Required Software Updates Using Horizon.

Procedure

Verify the state of the update.

~(keystone_admin)]$ sudo sw-patch query
Patch ID                         Patch State
=========================        ===========
STLX-00004-PATCH_0001         Applied

In this example the update is listed in the Applied state, but it could alo be in the Partial-Apply state.

Remove the update.
```
~(keystone_admin)]$ sudo sw-patch remove STLX-00004-PATCH_0001
STLX-00004-PATCH_0001 has been removed from the repo
```
The update is now in the Partial-Remove state, ready to be removed from the impacted hosts where it was currently installed.

Query the updating status of all hosts in the cluster.

~(keystone_admin)]$ sudo sw-patch query-hosts

  Hostname      IP Address     Patch Current  Reboot Required  Release  State
============  ===============  =============  ===============  =======  =====
worker-0      192.168.204.179       Yes             No          nn.nn   idle
worker-1      192.168.204.173       Yes             No          nn.nn   idle
controller-0  192.168.204.3         No              No          nn.nn   idle
controller-1  192.168.204.4         No              No          nn.nn   idle
storage-0     192.168.204.213       Yes             No          nn.nn   idle
storage-1     192.168.204.181       Yes             No          nn.nn   idle

In this example, the controllers have updates ready to be removed, and therefore must be rebooted.

Remove all pending-for-removal updates from controller-0.
1. Swact controller services away from controller-0.
2. Lock controller-0.
3. Run the updating (patching) sequence.
```
~(keystone_admin)]$ sudo sw-patch host-install-async controller-0
```
4. Unlock controller-0.
Remove all pending-for-removal updates from controller-1.
1. Swact controller services away from controller-1.
2. Lock controller-1.
3. Run the updating sequence.
4. Unlock controller-1.
```
~(keystone_admin)]$ sudo sw-patch host-install-async controller-1
```

Results

The cluster is up to date now. All updates have been removed, and the update STLX-00004-PATCH_0001 can be deleted from the storage area if necessary.

Remove Reboot-Required Software Updates

Remove Reboot-Required Software Updates¶

StarlingX